Cu-Cr-Zr合金时效后显微硬度和导电率的研究

行如意, 康布熙, 苏娟华, 田保红, 刘平

行如意, 康布熙, 苏娟华, 田保红, 刘平. Cu-Cr-Zr合金时效后显微硬度和导电率的研究[J]. 材料开发与应用, 2003, 18(4): 21-22,46. DOI: 10.19515/j.cnki.1003-1545.2003.04.006
引用本文: 行如意, 康布熙, 苏娟华, 田保红, 刘平. Cu-Cr-Zr合金时效后显微硬度和导电率的研究[J]. 材料开发与应用, 2003, 18(4): 21-22,46. DOI: 10.19515/j.cnki.1003-1545.2003.04.006
Xing Ruyi, Kang Buxi, Su Juanhua, Tian Baohong, Liu Ping. Study on Micro Hardness and Conductivity of Cu-Cr-Zr Alloy[J]. Development and Application of Materials, 2003, 18(4): 21-22,46. DOI: 10.19515/j.cnki.1003-1545.2003.04.006
Citation: Xing Ruyi, Kang Buxi, Su Juanhua, Tian Baohong, Liu Ping. Study on Micro Hardness and Conductivity of Cu-Cr-Zr Alloy[J]. Development and Application of Materials, 2003, 18(4): 21-22,46. DOI: 10.19515/j.cnki.1003-1545.2003.04.006

Cu-Cr-Zr合金时效后显微硬度和导电率的研究

基金项目: 

河南省重大科技攻关基金项目(0122021300)

详细信息
    作者简介:

    行如意,女,1978生,河南省孟州市人,硕士研究生。

  • 中图分类号: TG166.2

Study on Micro Hardness and Conductivity of Cu-Cr-Zr Alloy

  • 摘要: 研究了Cu-0.3Cr-0.15Zr-0.05Mg合金时效温度、时效时间和时效前变形量对导电率和显微硬度的影响。结果表明,合金920℃固溶后在450℃时效可以获得较高的硬度,在600℃时效可以获得较高的导电率;时效前冷变形可以加速第二相的析出,大幅度提高合金的导电率,合金固溶并60 %形变后在500℃时效0.5h导电率可达72.02%IACS,而固溶后直接时效仅为51.79%IACS。
    Abstract: The effects of aging and cold deforming on micro hardness and electrical conductivity of Cu-Cr-Zr alloy are studied in this paper. The results show that for the alloy solution treated at 920℃ for 1 hour,the higher micro hardness can be obtained when aged at 450℃ and the higher conductivity can be obtained when aged at 600℃ and cold deforming before aging is beneficial to improvement of the conductivity for it will accelerate the precipitation of the secondary phase of the alloy.Compared with 51.79%IACS as aged at 500℃ for 0.5h, the conductivity of the alloy 60% deformed reaches 72.02%IACS with the same aging treatment.
计量
  • 文章访问数: 
  • HTML全文浏览量: 
  • PDF下载量: 
  • 被引次数: 0
出版历程
  • 收稿日期:  2003-01-22
  • 网络出版日期:  2024-06-14

目录

    /

    返回文章
    返回