Volume 36 Issue 4
Aug.  2021
Turn off MathJax
Article Contents
Abstract
References
Related Articles
WANG Zhiqiang, LI Qiang, XIAO Yuchen. Safety Performance Analysis of Upper Locking Double-layer Non-linear Turnout Fasteners on the Upper Depot[J]. Development and Application of Materials, 2021, 36(4): 67-71.
Citation: WANG Zhiqiang, LI Qiang, XIAO Yuchen. Safety Performance Analysis of Upper Locking Double-layer Non-linear Turnout Fasteners on the Upper Depot[J]. Development and Application of Materials, 2021, 36(4): 67-71.
shu

Safety Performance Analysis of Upper Locking Double-layer Non-linear Turnout Fasteners on the Upper Depot

  • 1. Luoyang Sunrui Rubber&Plastic Technology Co. Ltd., Luoyang 471000, China;

  • 2. Power China Railway Construction Co. Ltd., Beijing 100089, China

More Information
  • Received Date: November 11, 2020
    Graphical Abstract
    • Abstract
  • The wheel-rail forces of 20 normal-operating trains passing through rails with upper locking double-layer non-linear turnout fasteners were tested on-site at the Metro and the data analyzed. The results showed when a train passed a double-layer non-linear turnout fastener, the maximum wheel load reduction rate was 0.14, the maximum derailment coefficient was 0.41, the average vertical force of the left and right wheels was 57.6 kN, and the average lateral force was 15.8 kN, which showed that the locking double-layer non-linear turnout fasteners on the upper part of the depot could fully meet the safety indicators of train operation.
    • FullText(HTML)
    • References (9)
  • [1]
    唐吉意,罗雁云,廖博,等.轨道科研试验线的轮轨力、脱轨系数及减载率研究[J].河北工程大学学报(自然科学版),2017,34(4):51-56.
    [2]
    魏来,曾京,邬平波,等.基于轮对模型的铁道车辆脱轨安全性评估[J].铁道学报,2015,37(9):25-31.
    [3]
    北京地铁16号线北安河车辆段振动加速度、轨道动态变形及轮轨力检测报告[R](报告编号:Q-2017-BJDT16JsZ-01).北京铁科工程检测中心,2017.
    [4]
    王志强,化一宁,孟鸿涛.上部锁紧式双层非线性减振扣件钢轨波磨的控制[J].噪声与振动控制,2018,38 (5):123-127.
    [5]
    TB/T 2489-2016,《轮轨横向力和垂直力地面测试方法》[S].
    [6]
    TB/T 2360-1993,铁道机车动力学性能试验鉴定方法及评定标准[S].
    [7]
    GB 5599-1985,铁道车辆动力学性能评定和试验鉴定规范[S].
    [8]
    GB/T 7928-2003,地铁车辆通用技术条件[S].
    [9]
    GB/T 14894-2005,城市轨道交通车辆组装后的检查与试验规则[S].
    • Related Articles

  • Related Articles

    [1]WU Jixiang, JIANG Peng, AN Feipeng. Research Progress and Prospect of Cold Cracking Sensitivity Evaluation of Welded Joints of Titanium Alloys[J]. Development and Application of Materials, 2021, 36(5): 76-82,102.
    [2]TAO Huifa, LI Bobo, LIU Yinqi. Analysis on Cracks in Cold Rolled Titanium Coil[J]. Development and Application of Materials, 2020, 35(1): 10-13.
    [3]MENG Fanming. Research Progress on Welding Cold Crack of Hull Structural Steel[J]. Development and Application of Materials, 2019, 34(6): 57-63. DOI: 10.19515/j.cnki.1003-1545.2019.06.012
    [4]CHENG Yingjin, LIU Haitao, DU Yi, YANG Shu, ZHENG Wenjian, DAI Xuejia. Analysis of 10Ni8CrMoV Steel Welding Cold Cracking Susceptibility on the Basis of Implant Test[J]. Development and Application of Materials, 2016, 31(5): 13-18. DOI: 10.19515/j.cnki.1003-1545.2016.05.004
    [5]WAN Songlin, WU Songlin. Numerical Simulation Analysis for the Welding Residual Stress of Low Strength Match Butt Joints[J]. Development and Application of Materials, 2015, 30(1): 33-37. DOI: 10.19515/j.cnki.1003-1545.2015.01.007
    [6]ZHOU Hong-bing, WU Song-lin, WANG Ren-fu, XUE Gang. Study on the Cold Cracking Sensibility of SH01 Electrode for Marine High Strength Steel[J]. Development and Application of Materials, 2014, 29(6): 34-37. DOI: 10.19515/j.cnki.1003-1545.2014.06.006
    [7]ZHANG Jing-hai, FANG Da-peng. Practicability Research on Low-match Weld Joint of High-Strength Steel[J]. Development and Application of Materials, 2012, 27(3): 1-6. DOI: 10.19515/j.cnki.1003-1545.2012.03.001
    [8]YAN Pei-jun, ZHANG Tian-hui, XU Ren-ping. Cold Crack Property Analysis of Steel WEL-TEN 62CF[J]. Development and Application of Materials, 2009, 24(4): 55-58. DOI: 10.19515/j.cnki.1003-1545.2009.04.014
    [9]WANG Xiao-hua, XIN Bao, SA Shi-yong, WU Lun-fa. Experimental Investigation on Cold Crack Sensibility of 321-Q370q Clad Plates[J]. Development and Application of Materials, 2008, 23(6): 54-57. DOI: 10.19515/j.cnki.1003-1545.2008.06.015
    [10]NIU Jing, DONG Jun-ming, HE Yuan, DONG Wei-peng, XUE Jin. Cold Cracking Sensitivity of Superhigh Strength Steel 30CrMnSiNi2A[J]. Development and Application of Materials, 2006, 21(4): 1-3. DOI: 10.19515/j.cnki.1003-1545.2006.04.001

Catalog

    Get Citation
    PDF
    XML

    Article Metrics

    Article views (181) PDF downloads (11) Cited by()
    Related

    Copyright © 《Development and Application of Materials》豫ICP备13020589号-2

    Adress: No.169, Binhe South Road, Luolong District, Luoyang City, Henan Province，China  Tel: (0379)67256265;  (0379)67256345  Email: TG023@163.com

    Supported by: Beijing Renhe Information Technology Co., Ltd.  Baidu Analytics

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return